Many people have a relatively simple understanding of rubber seals.
That is, they feel that they are characterized by an O-shaped circle.
But there are still many people who don’t know how to install rubber seals, so here, rubber seal manufacturers Let me introduce it to everyone.
When installing the rubber sealing ring.You should strictly clean all parts of the opened hydraulic system first.And it is best to use special tools to prevent fingers from being scratched by sharp metal edges.
Prevent overdue use. The service life of the dynamic seal rubber sealing ring is generally 3000~5000h, and the new rubber sealing ring should be replaced in time.
Avoid using old rubber seals. When using a new rubber sealing ring, carefully check its surface quality and make sure that it is free from defects such as small holes, protrusions, cracks and grooves and has sufficient elasticity before using it.
When replacing the rubber seal ring, check the groove of the rubber seal ring strictly, remove the dirt, and polish the bottom of the groove.
The rubber sealing ring can not be installed in the wrong direction and damage the lip. If there are scars over 50μm on the lips, it may cause obvious oil leakage.
Prevent the forced installation of rubber seals. Do not use a hammer to knock in, but use a special tool to first press the rubber seal into the seat hole, and then use a simple cylinder to protect the lip through the spline.
Before installation, apply some lubricating oil to the lips to facilitate installation and prevent burns during initial operation. Pay attention to cleaning.
The size of the replacement rubber seal should be the same.
It is necessary to strictly follow the requirements of the instructions, and use the same size rubber seals.
Otherwise the tightness and other requirements cannot be guaranteed.